Bacterial load

After counting all the appropriate plates, you proceed to calculate the concentration of viable bacteria in the original sample using the formula:

 

Number of Colonies × Dilution Factor = Colony Forming Units (CFUs)/mL. The results are shown below. 

 

#

Sample

Dilution series

Dilution Factor

Number of colonies

CFUs

A

Patient sample

10-1, 10-2, 10-3, 10-4

103

206

2.06 x 105

B

Meat storage area

10-2, 10-4, 10-6, 10-8

106

293

2.93 x 108

C

Cutting board

10-1, 10-2, 10-3, 10-4

102

180

1.80 x 104

D

Food preparation surface

10-2, 10-4, 10-6, 10-8

104

300

3.00 x 106

E

Sink 

10-1, 10-2, 10-3, 10-4

101

1

1.00

 

Dr. Spencer explains that the bacterial load is very high for the meat storage area, cutting board and food preparation surface and that the sink seems to be unaffected. 

 

[Specific thresholds are often defined by local or national health departments and organizations, such as the Food and Drug Administration in the United States or the European Food Safety Authority in the European Union. It is important for restaurants to adhere to these regulatory guidelines to ensure food safety compliance. A common guideline of acceptable levels is between ≤10 CFUs/m2 to ≤100 CFUs/m2. For precise numbers and guidance, specific regulations and recommendations of the relevant health authorities in specific areas will need to be followed.]

 

The patient sample results also support the notion that the patient got food poisoning. Dr. Spencer goes on to explain that these results will help the epidemiologist and sanitarian to properly disinfect the affected areas. At the same time, Dr. Spencer explains that there is still work to be done to identify the causative agen. This will be helpful not only for disinfection but also for choosing the most appropriate treatment for the patients. 


  • Streak plate method and pure cultures

Map: CS11 - MICROBIAL CULTURE AND GROWTH _ES (1054)
Node: 19886
Score:

reset

OpenLabyrinth
OpenLabyrinth is an open source educational pathway system

Review your pathway

  • Lysis in distilled water, normal shape in 0.9% NaCl and plasmolyse in 6% NaCl
  • Descontaminación y reinicio del experimento
  • Mr. Hartono panics
  • Método de siembra en estría y cultivos puros
  • what happened next
  • Experimento #2: Observación de las características de germinación de las semillas
  • Experimento #1: Medición del crecimiento bacteriano mediante densidad óptica
  • 2
  • 4
  • End
  • Observation under the microscope (animal cell)
  • The plate was not incubated at the appropriate temperature or CO₂ level.
  • 2, 4, 6
  • Contamination of media or poor aseptic technique.
  • Incorrect preparation of the nutrient-deprived media.
  • Carga bacteriana
  • Calmly explain the potential medication reaction and explicitly apply Evidence-Based Medicine (EBM) guidelines to manage the condition locally
  • Explain to Mr Hartono to remain calm and explain that the symptoms are caused by side effects of TB medication
  • End without a summary
  • Streak plate method and pure cultures
  • RT
  • Definition 2
  • Tell the patient to read the AVS alone without support.
  • Summarize the points
  • Send AVS without confirming understanding.
  • COPDAC (Cyclophosphamide, Vincristine/Oncovin, Prednisone, Dacarbazine)
  • Identification of mice carrying the transgene.
  • Preparación incorrecta del medio desprovisto de nutrientes
  • Definition 1
  • La placa no se incubó a la temperatura o al nivel de CO₂ adecuados
  • Contaminación del medio o técnica aséptica deficiente
  • Epilog: Un caz vechi rezolvat
  • Node 20: Encourage Maria to start the trial period
  • El espectrofotómetro
  • Chemical Hazards and Symbols
  • Επίλογος: Μια ανεξιχνίαστη υπόθεση εξιχνιάστηκε
  • Pericole și simboluri chimice
  • Bacterial load

Reminder

empty_reminder_msg

FINISH

Time is up